5.2.13 Preset tares
In addition the management of tares acquired from the weight present
on the scale and tares entered from the keypad, the terminal also
manages an archive of preset tares containing a number of values
difined during the installation phase. Each value can be recalled by way
of a 4 digit numeric code. Preset tares, once recalled by entering the
relative code, are automatically subtracted from the weight on the scale.
Preset codes may be entered by following the pathway:
...>MENU>Data management>Preset tare> Entering
(Shortcut keys TAREC and TARCn where n= 1,2 if multiple tares were set
during installation)
Select the tare type, enter the code number and press to confirm.
If necessary, enter the tare value.
The value TARE 2 can be multiplied by a number, designated the
Packs number , which may be entered from the keypad to obtain a
sum tare value (e.g. the sum of the tares of n containers of the same
weight). The Packs Number can be entered directly from the shortcut
key bar by pressing the key in correspondence to the indication PACKSN
. The functions TARE 1 and TARE 2 , together with the Packs Number
, allow weighing of products with both primary (e.g. pallets) and
secondary (e.g. boxes) packaging.
5.2.14 Preset tare list
By following the pathway:
...>MENU>Data management>Preset tare>Preset tare list
you can call up a tare code and display the corresponding tare value. To
recall a tare code, press the key in correspondence to the indication
TAREC , enter the numeric code and press to confirm.
If a printer is connected, on pressing the key in correspondence to the
indication SUMMAR you can print the data relative to a single tare code or
a summary of all the tare codes within a specified range.
D410
1-48
To Next Page
Loading...