On pressing again, the tare will be cancelled
and the terminal resumes display of the gross
weight.
Enter/display tare
Pressing this key allows you to enter a tare value
using the numeric keys on the keypad ( par. 4.3
on page 1-33 ). To change a preset tare value
see par. 5.2.13 on page 1-48 .
On completion of the operation, the display will
show the net weight and tare values and illuminate
the symbols and . The entered tare
value will be automatically rounded off to the
nearest scale division. On MD terminals, the net
weight will be displayed using the division of the
range within which the net weight value falls, while
on ME terminals, the net weight division shall be
that of the range within which the gross weight
falls. On MD terminals, the maximum preset tare
value is limited to the maximum capacity of the
first weighing extension (indicated on the
metrological data plate).
Print and/or send
Allows a weighing option to be requested.
Consequently forces a weighing data printout
and/or serial transmission of a string of data via
the configured port.
D410
1-32
To Next Page
Loading...