Press the switch on the rear of the terminal (see point 1 Figure 4.2 on
page 1-34 ) to position:
I to switch on the terminal;
O
to switch it off
On power on, the display will show the Manufacturer's logo and the type
of operation for which the terminal is enabled (see par. 5.4 on page
1-54 ).
Wait for the LOCK indication to appear (terminals subject to metrological
verification only).
If on completion of the operation the display shows a value other than
zero , press to zero-set the reading.
If the display is not zero-set on pressing the key:
✔
check that the platform scale is in fact unloaded. If not, unload the
scale, switch off the terminal and then switch it on again;
✔
If the problem persists, contact your Service Centre.
D410
1-35
To Next Page
Loading...