Key
U1,U2,U4,U8 = BCD units
(Binary Coded Decimal)
DE1,DE2,DE4,DE8 = BCD Tens
C1,C2,C4,C8 = BCD Hundreds
M1,M2,M4,M8 = BCD
Thousands
DM1,DM2,DM4,DM8 = BCD
Tens of thousands
CM1 = Hundreds of thousands
DVALID = (OUTPUT) can
assume the following values:
0: the data will be valid after 10
ms
1: the data will remain valid for
at least another 5 ms
NEG = (OUTPUT). Assumes the
value "0" (zero) when the weight
is negative
NC = Reserved - do not connect
DGND = Signal reference
common
Figure 6.3 - Parallel 5V TTL BCD output connector (log0060.gif)
D410
1-62
To Next Page
Loading...