EasyManua.ls Logo

Binder APT.line BD 53 - Intended Use of Equipment

Default Icon
55 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
BD / ED / FD (E2) 11/2010 page 15/54
DANGER
Electrical hazard.
Danger of death.
The unit must NOT become wet during operation or maintenance.
The incubators BD and heating ovens ED and FD have been produced in accordance with VDE
regulations and were routinely tested in accordance to VDE 0411-1 (IEC 61010-1).
CAUTION
The inner chamber, the outgoing air pipe, the door window (option), and the door
gaskets will become hot during operation.
Danger of burning.
Do NOT touch the inner surfaces, the door window, the access ports, the door gaskets
or the charging material during operation.
1.6 Intended use
1.6.1 Incubators BD
The incubators BD are designed for exact temperation of harmless materials. Because of their precise
temperature accuracy these devices are especially useful for incubation of cultures at a standard
temperature of 37 °C / 98.6 °F. Any solvent content must not be explosive or flammable. A mixture of any
component of the charging material with air must NOT be explosive. The operating temperature must lie
below the flash point or below the sublimation point of the charging material.
Other applications are not approved.
Do NOT use the unit for drying purpose, especially if greater quantities of steam leading to condensation
will be set free.
Observing the instructions in this operating manual and conducting regular maintenance work
(chap. 9) is part of the intended use.
1.6.2 Heating ovens ED and FD
The heating ovens ED and FD are suitable for drying and heat treatment of solid or pulverized charging
material, as well as bulk material, using the supply of heat. The solvent content must not be explosive or
flammable. A mixture of any component of the charging material with air must NOT be explosive. The
operating temperature must lie below the flash point or below the sublimation point of the charging
material.
Other applications are not approved.
Do NOT use the unit for drying purpose, especially if greater quantities of steam leading to condensation
will be set free.
Due to the special demands of the Medical Device Directive (MDD) this ovens are not qualified for
sterilization of medical devices as defined by the directive 93/42/EWG.
Observing the instructions in this operating manual and conducting regular maintenance work
(chap. 9) is part of the intended use.

Table of Contents

Related product manuals