Binder APT.line BD 53 - Maintenance, Cleaning, and Service; Maintenance Intervals and Service

BD / ED / FD (E2) 11/2010 page 33/54
8.5 Water protected internal socket (option BD)
The internal socket is splash proof.
IP system of protection 65 230 V 1N ~ 50-60 Hz
Charge max. 500 W
Maximum permitted operating temperature with this option: 50 °C / 122 °F.
WARNING
Exceeding of the permitted maximum temperature.
Electrical hazard.
Danger of death.
Damage to the internal socket.
∅ Do NOT exceed the temperature set-point of 50 °C / 122 °F.
 Set the mechanical thermostat class 3.1 to 50 °C / 122 °F.
Heat emission of electrical devices connected inside the chamber may modify the
temperature range.
CAUTION
Risk of short circuit.
Damage to the unit.
 Use the delivered plug only (IP protection type 66). Plug-in the plug and turn it to
secure.
 If the socket is not used, close the lift-up lid and turn it for securing.
9. Maintenance, cleaning, and service
9.1 Maintenance intervals, service
DANGER
Electrical hazard.
Danger of death.
∅ The unit must NOT become wet during operation or maintenance work.
∅ Do NOT remove the rear panel of the unit.
 Disconnect the unit before conducting maintenance work. Disconnect the power plug.
 Ensure all maintenance work is conducted by licensed electricians or experts
authorized by BINDER.
Ensure regular maintenance work is performed at least once a year.
Replace the door gasket only when cold. Otherwise, the door gasket may become damaged.