Binder APT.line BD 53 - FD Technical Data

BD / ED / FD (E2) 11/2010 page 44/54
Unit size ED 23 ED 53 ED 115 ED 240 ED 400 ED 720
Ventilation data
at 70 °C / 158 °F x/h 10 8 12 11 11 10
at 150 °C / 302 °F x/h 13 12 10 10 10 9
Air change
at 300 °C / 572 °F x/h 17 20 10 9 9 8
Electrical data
IP system of protection acc. to EN 60529 20 20 20 20 20 20
Nominal voltage (±10%) 50/60 Hz V 230 1N~ 230 1N~ 230 1N~ 230 1N~ 400 3N~ 400 3N~
Nominal power kW 0.8 1.20 1.60 2.70 3.40 5.00
at 70 °C / 158 °F Wh/h 43 60 90 143 201 220
at 150 °C / 302 °F Wh/h 148 210 300 447 672 750
Energy
consumption
at 300 °C / 572 °F Wh/h 450 600 360 700 1000 1200
Unit fuse
5 x 20 mm / 230V / middle-time-lag (M)
Amp 10
external
10
external
10
external
16
external
3 x 16
internal
3 x 16
internal
Power plug shock proof plug CEE plug 5 poles
Installation category acc. to IEC 61010-1 II II II II II II
Pollution degree acc. to IEC 61010-1 2 2 2 2 2 2
Electrical connection data ED-UL acc. to cUL standard (for USA and Canada):
Unit size ED 23-
UL
ED 53-
UL
ED 115-
UL
ED 240-
UL
ED 400-
UL
ED 720-
UL
Electrical data
Nominal voltage (±10%) 60 Hz V 115 1N~ 115 1N~ 115 1N~ 208 3N~ 208 3N~ 208 3N~
Nominal power kW 0.80 1.20 1.60 2.70 3.40 5.00
Nominal current Amp 7.0 10.5 14.0 11.2 10.6 15.6
Power plug NEMA 5-20P 5-20P 5-20P L21-20P L21-20P L21-20P
Unit fuse
6,3 x 32 mm / 250V / super-time-lag TT
Amp 12.5
external
16
external
16
external
3 x 16
internal
3 x 16
internal
3 x 16
internal
Legend: 1) without outer glass door 2) up to 98 % of the set value
All technical data is specified for units with standard equipment at an ambient temperature of +25 °C / 77
°F and a power supply voltage fluctuation of ±10. The temperature data is determined in accordance to
BINDER factory standard following DIN 12880, observing the recommended wall clearances of 10 % of
the height, width and depth of the inner chamber.
All indications are average values, typical for units produced in series. We reserve the right to
change technical specifications at any time.
If the cabinet is fully loaded, the specified heating up times may vary according to the load.
12.6 FD technical data
Unit size FD 23 FD 53 FD 115 FD 240
Exterior dimensions
Width mm / inch 435 / 17.13 635 / 25.00 835 / 32.87 1035 / 40.7
5
Height (incl. feet) mm / inch 495 / 19.49 620 / 24.41 705 / 27.76 825 / 32.48
Depth mm / inch 520 / 20.47 575 / 22.64 645 / 25.39 745 / 29.33
incl. door handle and exhaust duct mm / inch 105 / 4.13 105 / 4.13 105 / 4.13 105 / 4.13
Wall clearance rear mm / inch 100 / 3.94 100 / 3.94 100 / 3.94 100 / 3.94
Wall clearance side mm / inch 100 / 3.94 160 / 6.30 160 / 6.30 160 / 6.30
Exhaust duct, outer diameter mm / inch 52 / 2.05 52 / 2.05 52 / 2.05 52 / 2.05
Steam space volume l / cu.ft. 36 / 1.27 77 / 2.72 158 / 5.58 308 / 10.88
Number of door(s) 1 1 1 2