MKF / MKFT (E5) 04/2022 page 129/176
BINDER GmbH is NOT responsible for the water quality at the user’s site, especially when
reusing wastewater.
Any problems and malfunctions that might arise following use of wastewater are excluded
from liability by BINDER GmbH.
Cable connection between the pump and the climatic chamber
Connect the cable plug from the cable connection (21) on the pump to the socket (18) at the rear of the
chamber as described in chap. 21.9.1.
Hose connection between the wastewater hose of the climatic chamber and the freshwater can
Plug the wastewater hose into the hose connection (24) of the freshwater can and secure it with a hose
clamp. You can use a part of the standard supplied water hose.
Plug the free hose edge to the wastewater connection “OUT” (14) at the rear of the chamber and secure it
with a hose clamp.
Hose connection (24)
of the freshwater can
Figure 27: Freshwater can
Bringing a source of humidity into the inner chamber may increase wastewater production.
Regularly check the filling level of the freshwater can.
21.9 BINDER Pure Aqua Service (option)
The optional BINDER water treatment system (disposable system) serves to treat tap water. The lifetime
depends on water quality and the amount of treated water. The measuring equipment to assess the water
quality is reusable.
For detailed information on operating the water treatment system BINDER Pure Aqua Ser-
vice and its function, please refer to the operating manual, supplied with BINDER Pure
Aqua Service.
22. Cleaning and decontamination
Clean the chamber after each use in order to prevent potential corrosion damage by ingredients of the
loading material.
Prior to renewed startup, allow the chamber to completely dry after all cleaning and decontamination
measures.
To Next Page
Loading...
