Binder VD 23 - 25 Disposal; Disposal of the Transport Packing; Decommissioning

VD (E3.1) 03/2020 page 152/173
25. Disposal
25.1 Disposal of the transport packing
Packing element
Material
Disposal
Straps to fix packing on pallet
Plastic
Plastic recycling
Wooden transport box (option)
with metal screws
Non-wood (compressed
matchwood, IPPC standard)
Wood recycling
Metal
Metal recycling
Pallet
with foamed plastic stuffing
Solid wood (IPPC standard)
Wood recycling
PE foam
Plastic recycling
Shipping box
with metal clamps
Cardboard
Paper recycling
Metal
Metal recycling
Top cover
Cardboard
Paper recycling
Edge protection
Styropor
®
or PE foam
Plastic recycling
Protection of doors
PE foam
Plastic recycling
Bag for operating manual
PE foil
Plastic recycling
Insulating air cushion foil (packing of
optional accessories)
PE foil Plastic recycling
If recycling is not possible, all packing parts can also be disposed of with normal waste.
25.2 Decommissioning
• Disconnect the oven from the power supply. Disconnect the power plug.
• Turn off the inert gas supply.
Through the open inert gas connection, inert gas can enter the vacuum drying oven and escape into
the ambient air.
DANGER
Risk of suffocation by inert gas in a high concentration.
Death by suffocation.
 Respect the relevant regulations for handling inert gases.
 When decommissioning the vacuum drying oven, turn off the inert gas supply.
• Turn off the vacuum pump. Ventilate the chamber as described in chap. 6.3.2
• Disconnect the oven from the power supply. Pull the power plug.
• Remove the vacuum connection (chap. 4.3).
• Remove the inert gas connection and the pressure reducer (chap. 4.5).
Temporal decommissioning: See indications for appropriate storage, chap. 3.3.
Final decommissioning: Dispose of the chamber as described in chap. 24.3 to 24.5.