Clean the Internal Components | 61
Required Materials
Warning! Always wear protective gloves and safety
glasses when performing cleaning/maintenance
procedures.
For all tasks:
• Protective gloves
• Safety glasses
For removing the shroud and some of the internal components:
• Screwdriver
• 1/8" hex key
• 3/32" hex key
For cleaning the internal dispense tubes and injector heads, as well as for wiping
the surface under the plate carrier:
• Mild detergent
• Clean, lint-free cotton cloths
• Deionized or distilled water
• Stylus (stored in a plastic cylinder affixed to the rear of the dispense
module or reader) (PN 2872304)
For cleaning the optical probes:
• Clean cotton swabs
• Isopropyl alcohol
• Lens-cleaning tissue
Synergy HTX Operator's Manual
To Next Page
Loading...
Need help?
General
