Bizerba A400 - Table of Contents

Instruction manual A400 / A400FB Contents
6.054.98.5.10.06 en 0 - 1
Contents Page
1 About these instructions ............................................ 1 - 1
1.1 Safe-keeping ................................................ 1 - 1
1.2 Target group ................................................. 1 - 1
1.3 Symbols used ................................................ 1 - 1
1.4 Warnings .................................................... 1 - 2
2 About this machine ................................................. 2 - 1
2.1 Intended use ................................................. 2 - 1
2.2 Machine description .......................................... 2 - 2
2.2.1 Descriptions of components A400 ............................. 2 - 3
2.2.2 Descriptions of components A400FB ........................... 2 - 5
2.2.3 Accessories .................................................. 2 - 6
2.3 Directives .................................................... 2 - 6
2.4 Warranty .................................................... 2 - 6
2.5 Disposal of the machine / environmental protection ............. 2 - 7
3 Safety instructions ................................................. 3 - 1
3.1 General notes on safety ...................................... 3 - 1
3.2 Safety instructions for transport and installation ................. 3 - 2
3.3 Safety instructions during operation, slicing ..................... 3 - 2
3.4 Safety instructions for sharpening, cleaning .................... 3 - 2
3.5 Protective and safety equipment ............................... 3 - 3
3.6 Plates on machine ............................................ 3 - 4
4 Installation ......................................................... 4 - 1
4.1 Transport and storage ........................................ 4 - 1
4.2 Installation and assembly ..................................... 4 - 1
4.2.1 Installation requirements ...................................... 4 - 1
4.2.2 Electrical connection .......................................... 4 - 2
4.3 Start-up ..................................................... 4 - 3
4.3.1 Switching the slicer on ........................................ 4 - 3
4.3.2 Switching the machine off ..................................... 4 - 3
4.4 Placing out of operation ....................................... 4 - 3