Instruction manual A400 / A400FB Installation
6.054.98.5.10.06 en 4 - 5
4
Selectable are:
– Light sensor
– Insertion plate set and remnant holder
– External switch off option
4.5.1 Installation of conveying belts and light sensor
For a detailed description, please see chapter 8.5
Fig. 11: Conveyor belt version 2 x 115 mm
Use both hands to hold the conveyor
belt on its sides.
Put the belt bearing down onto the take-
up pin, keeping it in a slight tilted posi-
tion.
Push the belt as far as it will go towards
the coupling, if necessary turn the drive
shaft until it connects with the coupling
bolts.
Secure the conveyor belt by setting the
lock at the belt support.
Damaged or twisted wire meshing can
cause operational malfunctions.
Adjustment of conveyor belt to various insertion positions
Fig. 12: Height adjustment of conveyor belt
Turn stop latches underneath conveyor
belt.
A height adjustment of 80 mm in total is
possible to adjust the conveyor belt to the
different insertion positions of the pack-
aging machine.
To Next Page
Loading...
Need help?
General
