Operation Modes 49
6.3.2 Run List
To run a previously saved list le:
Step 1. Press the + buttons to enter the LIST menu.
Step 2. Use the right and left navigation keys to select CALL, then press the
Step 3. Use the numeric keypad to set the RECALL LIST. Press the to recall the specied list
le.
Step 4. Use the right and left navigation keys to select OFF, then press the to enable list mode.
If the OFF option is not available and ON is displayed, list mode is already
enabled
Step 5. Press the to exit the LIST menu.
The center of the display will now show L<n>, signaling that list mode is active,
where <n> corresponds to the active list le.
Step 6. Enable the input and provide the required trigger function to run the list.
– The initiation trigger required will vary based on the currently set trigger type. For additional
details on the available trigger types, please refer to section 7.5.
To Next Page
Loading...
