Safety Notices
The following safety precautions apply to both operating and maintenance personnel and must be followed
during all phases of operation, service, and repair of this instrument.
Before applying power to this instrument:
• Read and understand the safety and operational information in this manual.
• Apply all the listed safety precautions.
• Verify that the voltage selector at the line power cord input is set to the correct line voltage. Operating
the instrument at an incorrect line voltage will void the warranty.
• Make all connections to the instrument before applying power.
• Do not operate the instrument in ways not specied by this manual or by B&K Precision.
Failure to comply with these precautions or with warnings elsewhere in this manual violates the safety
standards of design, manufacture, and intended use of the instrument. B&K Precision assumes no
liability for a customer’s failure to comply with these requirements.
Electrical Power
This instrument is intended to be powered from a CATEGORY II mains power environment. The mains
power should be 115 V RMS or 230 V RMS. Use only the power cord supplied with the instrument and
ensure it is appropriate for your country of use.
Do not use this instrument in an electrical environment with a
higher category rating than what is specied in this manual for this
instrument.
You must ensure that each accessory you use with this instrument
has a category rating equal to or higher than the instrument’s
category rating to maintain the instrument’s category rating. Failure
to do so will lower the category rating of the measuring system.
To Next Page
Loading...
