OUTPut Subsystem
This subsystem controls the output of the power supply.
:OUTPut[:STATe] {0|1|OFF|ON}
This command enables and disables the output of the power supply. You can
replace off | on parameters with 0 | 1 numeric values.
When output is enabled, the power supply will display voltage and current
value measured on the output terminals of the power supply.
When output is disabled, the power supply will display Output Off message
and the indicators according to power supply’s state.
When output is disabled, output voltage is 0 V and the current is 0.002 A.
When delivered, after power on reset, output will be disabled (it depends on the
parameters saved in power_up location).
OUTPut[:STATe]?
This command queries the output state of the power supply. It returns only
numeric values: 0 (for off state) or 1 (for on state)
To Next Page
Loading...
Need help?
General
