724-746-5500 | blackbox.com
724-746-5500 | blackbox.com
Page 113
Chapter 3: Configuration
3.12 VLAN
This section describes how to assign a specific VLAN for management purpose. The management VLAN is used to establish an IP
connection to the switch from a workstation connected to a port in the VLAN. This connection supports a VSM, SNMP, and
Telnet session. By default, the active management VLAN is VLAN 1, but you can designate any VLAN as the management VLAN
by configuring System->IP->IPv4->VLAN ID. Only one management VLAN can be active at a time.
Figure 3-55. IP Configuration for management VLAN screen.
When you specify a new management VLAN, your HTTP connection to the old management VLAN is lost. For this reason, you
should have a connection between your management station and a port in the new management VLAN or connect to the new
management VLAN through a multi-VLAN route.
LPB2810A
To Next Page
Loading...
