724-746-5500 | blackbox.com
Page 14
724-746-5500 | blackbox.com
Chapter 1: Overview
1.3 Network Wiring Connections
Today, the punchdown block is an integral part of many of the newer equipment racks. It is actually part of the patch panel.
Instructions for making connections in the wiring closet with this type of equipment follows:
Step 1: Attach one end of a patch cable to an available port on the switch, and the other end to the patch panel.
Step 2. If not already in place, attach one end of a cable segment to the back of the patch panel where the punchdown block is
located, and the other end to a modular wall outlet.
Step 3. Label the cables to simplify future troubleshooting. See Chapter 6 of the PoE+ Gigabit Managed Switch Eco Quick Start
Guide: “Labeling Connections.“
Punchdown Block
Wall
Patch Panel
Switch
Equipment Rack
(side view)
Figure 1-3. Network wiring connections.
LPB2810A
To Next Page
Loading...
