724-746-5500 | blackbox.com
724-746-5500 | blackbox.com
Page 147
Chapter 3: Configuration
3.16.8 DSCP Translation
This section describes how you can configure the basic QoS DSCP Translation settings for all switches. DSCP Translation can be
done in Ingress or Egress.
Web Interface
To configure the DSCP Translation parameters in the Web interface:
1. Click Configuration, QoS, DSCP Translation.
2. Scroll to set the Ingress Translate and Egress Remap DP0 and Remap DP1 Parameters.
3. Evoke to enable or disable Classify.
4. Click the Save button to save the setting.
5. To cancel the setting, click the Reset button to revert to previously saved values.
Figure 3-81. The DSCP Translation Configuration screen
LPB2810A
To Next Page
Loading...
