724-746-5500 | blackbox.com
Page 94
724-746-5500 | blackbox.com
Chapter 3: Configuration
3.9.2 LLDP Neighbors
This page provides a status overview for all LLDP neighbors. The displayed table contains a
row for each port on which an LLDP neighbor is detected. The columns hold the following
information:
Web Interface
To show LLDP neighbors:
1. Click LLDP Neighbors.
2. Click Refresh for manual update Web screen.
3. Click Auto-refresh for auto-update Web screen.
Figure 3-44: The LLDP Neighbor information screen.
NOTE: If your network supports LLDP, without any external devices connected, then the table will say “No LLDP neighbor
information found”.
Parameter Description
• Local Port: The port on which the LLDP frame was received.
• Chassis ID: The Chassis ID is the identification of the neighbor's LLDP frames.
• Remote Port ID: The Remote Port ID is the identification of the neighbor port.
• System Name: System Name is the name advertised by the neighbor unit.
• Port Description: Port Description is the port description advertised by the neighbor unit.
• System Capabilities: System Capabilities describes the neighbor unit’s capabilities. The possible capabilities are:
1. Other
2. Repeater
3. Bridge
4. WLAN Access Point
5. Router
6. Telephone
7. DOCSIS cable device
8. Station only
9. Reserved
When a capability is enabled, the capability is followed by (+). If the capability is disabled, the capability is followed by (-).
LPB2810A
To Next Page
Loading...
