724-746-5500 | blackbox.com
724-746-5500 | blackbox.com
Page 215
Chapter 5: Maintenance
5.5.2 Ping6
This section enables you to issue ICMPv6 PING packets to troubleshoot IPv6 connectivity issues.
Web Interface
To configure an ICMPv6 PING Configuration in the web interface:
1.Specify ICMPv6 PING IP Address.
2.Specify ICMPv6 PING Size.
3.Click “Start.“
Figure 5-11. The ICMPv6 Ping screen.
Parameter Description
• IP Address: The destination IP Address with IPv6.
• Ping Size: The payload size of the ICMP packet. Values range from 8 bytes to 1400 bytes.
• Start: Click the “Start” button. The switch will start to ping the device using the ICMPv6 packet size set in the “Ping Size“ entry
that has been set.
After pressing “Start,” five ICMPv6 packets will be transmitted. The sequence number and roundtrip time are displayed upon
reception of a reply. The page refreshes automatically until responses to all packets are received, or until a timeout occurs.
PING6 ser ver 10.10.132.20
64 bytes from 10.10.132.20: icmp_seq=0, time=0ms
64 bytes from 10.10.132.20: icmp_seq=1, time=0ms
64 bytes from 10.10.132.20: icmp_seq=2, time=0ms
64 bytes from 10.10.132.20: icmp_seq=3, time=0ms
64 bytes from 10.10.132.20: icmp_seq=4, time=0ms
Sent 5 packets, received 5 OK, 0 bad
LPB2810A
To Next Page
Loading...
