724-746-5500 | blackbox.com
Page 150
724-746-5500 | blackbox.com
Chapter 3: Configuration
3.16.10 QoS Control List Configuration
This section shows the QoS Control List (QCL), which is made up of the QCEs. Each row describes a QCE that is defined. The
maximum number of QCEs is 256 on each switch. Click on the lowest plus sign to add a new QCE to the list.
Web Interface
To configure the QoS Control List parameters in the Web interface:
1. Click Configuration, QoS, QoS Contol List.
2. Click the to add a new QoS Control List.
3. Scroll all parameters and evoke the Port Member to join the QCE rules.
4. Click the Save button to save the setting.
5. To cancel the setting, click the Reset button to revert to previously saved values.
Figure 3-83. The QoS Control List Configuration screen.
Parameter Description
• QCE#: Indicates the index of QCE.
• Port: Indicates the list of ports configured with the QCE.
• Frame Type: Indicates the type of frame to look for incoming frames. Possible frame types are:
Any: The QCE will match all frame types.
Ethernet: Only Ethernet frames (with Ether Type 0x600-0xFFFF) are allowed.
LLC: Only (LLC) frames are allowed.
SNAP: Only (SNAP) frames are allowed
IPv4: The QCE will match only IPV4 frames.
IPv6: The QCE will match only IPV6 frames.
LPB2810A
To Next Page
Loading...
