724-746-5500 | blackbox.com
724-746-5500 | blackbox.com
Page 131
Chapter 3: Configuration
• Timer Values: To set the GARP join timer, leave timer, and leave all timers, the unit is microseconds (ms).
Three different timers can be configured on this page:
- Join Timer: The default value for Join timer is 200 ms.
- Leave Timer: The range of values for Leave Time is 600–1000 ms. The default value for Leave Timer is 600 ms.
- Leave All Timer: The default value for Leave All Timer is 10000 ms.
• Application: Currently only supported application is GVRP.
• Attribute Type: Currently only supported Attribute Type is VLAN.
• GARP Applicant: This configuration is used to configure the Applicant state machine behavior for GARP on a particular port
locally.
- normal-participant: In this mode the Applicant state machine will operate normally in GARP protocol exchanges.
- non-participant: In this mode the Applicant state machine will not participate in the protocol operation.
The default configuration is normal participant.
• Buttons:
- Save: Click to save changes.
- Reset: Click to undo any changes made locally and revert to previously saved values
LPB2810A
To Next Page
