724-746-5500 | blackbox.com
Page 140
724-746-5500 | blackbox.com
Chapter 3: Configuration
Selecting “Weighted“ mode
will display this screen
instead of that shown in
Figure 3-65.
Figure 3-75. The QoS Egress Port Scheduler front screen in Weighted mode.
Parameter Description
• Port: The logical port for the settings contained in the same row. Click on the port number to configure the schedulers.
• Mode: Shows the scheduling mode for this port.
• Weight (Qn): Shows the weight for this queue and port.
• Scheduler Mode: Controls whether the scheduler mode is "Strict Priority" or "Weighted" on this switch port.
• Queue Shaper Enable: Controls whether the queue shaper is enabled for this queue on this switch port.
• Queue Shaper Rate: Controls the rate for the queue shaper. The default value is 500. This value is restricted to 100–1,000,000
when the “Unit“ is “kbps“, and it is restricted to 1–1000 when the “Unit“ is “Mbps.“
• Queue Shaper Unit: Controls the unit of measure for the queue shaper rate as “kbps“ or “Mbps“. The default value is “kbps“.
• Queue Shaper Excess: Controls whether the queue is allowed to use excess bandwidth.
• Queue Scheduler Weight: Controls the weight for this queue. The default value is “17.“ This value is restricted to 1–100. This
parameter is only shown if “Scheduler Mode“ is set to “Weighted.“
• Queue Scheduler Percent: Shows the weight in percent for this queue. This parameter is only shown if “Scheduler Mode“ is
set to “Weighted.“
• Port Shaper Enable: Controls whether the port shaper is enabled for this switch port.
• Port Shaper Rate: Controls the rate for the port shaper. The default value is 500. This value is restricted to 100–1,000,000
when the “Unit“ is “kbps,“ and it is restricted to 1–1000 when the “Unit“ is “Mbps.“
• Port Shaper Unit: Controls the unit of measure for the port shaper rate as “kbps“ or “Mbps.“ The default value is “kbps.“
• Buttons:
- Save: Click to save changes.
- Reset: Click to undo any changes made locally and revert to previously saved values.
LPB2810A
To Next Page
Loading...
