724-746-5500 | blackbox.com
Page 142
724-746-5500 | blackbox.com
Chapter 3: Configuration
Selecting “Weighted“ mode
will display this screen
instead of that shown in
Figure 3-65.
Figure 3-77. The QoS Egress Port Shapers screen, Weighted mode.
Parameter Description
• Port: The logical port for the settings contained in the row. Click on the port number to configure the shapers.
• Shapers (Qn): Shows “disabled“ or actual queue shaper rate, e.g. “800 Mbps.“
• Shapers (Port): Shows “disabled“ or actual port shaper rate, e.g. “800 Mbps.“
• Scheduler Mode: Controls whether the scheduler mode is “Strict Priority“ or “Weighted“ on this switch port.
• Queue Shaper Enable: Controls whether the queue shaper is enabled for this queue on this switch port.
• Queue Shaper Rate: Controls the rate for the queue shaper.
• Queue Shaper Unit: Controls the unit of measure for the queue shaper rate as “kbps“ or “Mbps.“ The default value is “kbps.“
• Queue Shaper Excess: Controls whether the queue is allowed to use excess bandwidth.
• Queue Scheduler Weight: Controls the weight for this queue. The default value is “17.“ This value is restricted to 1–100. This
parameter is only shown if “Scheduler Mode“ is set to “Weighted.“
• Queue Scheduler Percent: Shows the weight in percent for this queue. This parameter is only shown if “Scheduler Mode“ is
set to “Weighted.“
• Port Shaper Enable: Controls whether the port shaper is enabled for this switch port.
• Port Shaper Rate: Controls the rate for the port shaper.
• Port Shaper Unit: Controls the unit of measure for the port shaper rate as “kbps“ or “Mbps.“ The default value is “kbps.“
• Buttons:
- Save: Click to save changes.
- Reset: Click to undo any changes made locally and revert to previously saved values.
LPB2810A
To Next Page
Loading...
