Focus Peaking
Allows you to change the level of focus peaking. The settings include: off, low, medium and
high. Adjust this setting when you are using a very sharp lens and the peaking covers the entire
image. The default setting is medium.
Front Tally Brightness
Changes the brightness of the front tally light. Settings include: off, low, medium and high.
Thedefault setting is medium.
Rear Tally Brightness
Changes the brightness of the rear tally light. Settings include: low, medium and high.
Thedefault setting is medium.
Tally Light Brightness
Changes the brightness of the tally light on Micro Studio Camera 4K. The default setting is
medium but you can also set it to high, low or off.
If you have set the tally brightness to ‘off’, the tally light will illuminate when your camera is
powered on, and then will turn off shortly afterwards.
Display Battery Percentage
Some LP-E6 batteries can tell the camera their charge levels directly via digital serial
communication. If this option is enabled, you can display the battery levels for Micro Studio
Camera 4K using a percentage value instead of graphical bars. However, if you find the
percentage display inaccurate, you can switch back to using graphical bars which measures of
the state of charge directly off the battery.
Studio Settings
To adjust the display settings for the LCD, press the ‘menu’ button and select the headphones
icon. Use the menu navigation buttons to highlight menus and use the ‘set’ button to confirm
your selection.
Studio settings - Blackmagic Studio Camera.
Camera Number
If you want your Studio Camera to receive tally signals from an ATEM switcher, you’ll need to set
the camera number on your camera. This ensures the switcher sends the tally signal to the
correct camera. The camera number can be set to a value of 1-99. The default setting is 1.
2424Settings
To Next Page
Loading...
