TIP When the shot number or scene letter advance the take number reverts to ‘1.’
You can add descriptions in the take number editor. These are on the right of the take number
keyboard and correspond to the following scenarios:
PU
‘Pick up.’ This refers to a reshoot of a previous take to add additional material after
principal photography has wrapped.
VFX ‘Visual effects.’ This refers to a take or shot for visual effect use.
SER
'Series.' This refers to a situation in which multiple takes are shot while the camera is
kept running.
Tap ‘A’ to enable ‘auto take increment’ when in ‘standby’ mode. This
will automatically advance the take number for each clip recorded.
A small ‘A’ appears next to the take number on the slate when
enabled. When entering ‘take’ metadata, prompts for additional
shot types will appear to the right of the touch keyboard
Good take
Tap the ‘good take’ indicator to tag good takes for easy recall in post production. This button
applies the ‘good take’ tag to the clip currently being viewed in ‘playback’ mode. If the camera
is in ‘standby’ mode and ready to record, the ‘good take last clip’ button applies a ‘good take’
tag to the last clip recorded.
Interior / Exterior
Tap ‘interior’ or ‘exterior’ to add a tag to the next clip in standby mode, or the current clip in
playback mode.
Day / Night
Tap the ‘day’ or ‘night’ icons to add a ‘day’ or ‘night’ tag to the next clip in standby mode,
orthecurrent clip in playback mode.
48Entering Metadata
To Next Page
Loading...
Need help?
General
