Jog
Jog mode offers precise control over tape and drive based decks with a slower speed
compared to ‘shuttle’ mode. Press the jog button to select jog mode and the button will
illuminate. The search dial will now respond to how fast you rotate the dial. The dial will spin
freely without any clutch engaging.
Jog backward Jog forward
Light indicators will display the
direction of your search dial position.
TIP You may find you use two or three search dial modes to find your timecode point.
Use ‘shuttle’ mode as a quick way to navigate to the area ofinterest, then change to
jog mode for more precision.
Position
Position mode lets your navigate to your area of interest based on the duration of the tape
or timeline you are viewing. On a traditional tape based broadcast deck, ‘position’ indicates
whether you are near the start or end of a recorded tape. For a HyperDeck, ‘position’ indicates
your location relevant to the timeline position.
The light indicators when in ‘position’ mode will indicate the position relative to the start
middle and end.
Near start of timeline Center of timeline
Towards end of timeline End of timeline
Position mode lights indicate your
position relative to the timeline
74HyperDeck Extreme Control Workflow
To Next Page
Loading...
Need help?
General
