11
Installation
Electrical Supply
NOTE: Electrical connections must be performed by a
qualied installer only.
Before making any electrical connections to these appli-
ances, check that the power supply is adequate for the
voltage, amperage, and phase requirements stated on
the rating name plate mounted on the appliance.
The circuit breaker that is used to provide power to this
appliance must have a minimum of .076” (3mm) contact
spacing. The circuit breaker must meet all Local and Na-
tional installation standards.
All appliances must be installed in accordance with Local
or National Electrical codes.
A wiring schematic is located in the slide out panel.
NOTE: Disconnect the power supply to the appliance be-
fore servicing.
WARNING!!
Improper installation may invalidate your war-
ranty.
A strain relief for the power supply cord is provided.
WARNING!!
If the supply cord is damaged, it must be
replaced by a special cord or assembly avail-
able from the manufacturer or its service
agent.
Figure 11
To Next Page
Loading...
