16
Operation
MenuSelect Control
7. Use the arrows to select the fan rotation cycle.
Choose between manual or auto.
NOTE: This is the length of time the fan will rotate in
one direction before reversing.
If manual is selected, use the arrows or the alpha/
numeric keypad to enter the desired fan cycle. Press
OK to set the fan cycle.
If auto is selected, the program will use the default
fan cycle setting. The default is set through the Man-
ager Programming. See page 17.
8. Use the arrows to set the vent position.
Choose between OPEN or CLOSE. Press OK to set
the vent position.
9. Use the arrows to scroll down to PRODUCT NAME:
STAGE 2. Press OK to select stage 2.
10. Repeat steps 2-9 for all remaining stages.
11. When al stages have been programmed, press the
PROGRAM KEY (17). To save the programming, use
the arrows to scroll to YES. Press OK. The control
exits the program mode.
USING THE USB PORT
1. With the power on, remove the cover of the USB port
(24) and insert the USB drive.
2. Press the MAINTENANCE KEY (19).
3. Turn the dial to highlight MANAGER PROGRAM.
Press the center of the dial to select.
4. Turn the dial to highlight either COPY RECIPE FROM
USB or COPY RECIPE TO USB, then press the cen-
ter of the dial to select.
5. When the transfer is complete, press any key to re-
turn to the menu.
6. Turn the dial to highlight EXIT. Press the center of
the dial to select. The display returns to the previous
menu.
7. Turn the dial to highlight EXIT. Press the center of the
dial to select.
To Next Page
Loading...
Need help?
General
