17
Operation
MenuSelect Control
MANAGER PROGRAMMING
Entering the Manager Program Mode
1. Press the MAINTENANCE KEY (19). If the control
is password protected, the display reads ENTER
CODE. Use the alpha/numeric keypad to enter the
manager passcode. Press OK to enter the program
mode.
2. Use the arrows to highlight OVEN SETUP.
Press OK to select the product.
Programming Auto Start
NOTE: The Auto Start function enables the oven to turn
on at a programmed time of day and preheat to a
programmed temperature.
1. Use the arrows to highlight AUTO START. Press OK
to select.
2. Use the arrows to select either ON or OFF. Press OK
to select.
If ON is selected, the display reads AUTO START 24
HOUR TIME 00:00. Use the arrows to enter the time
you would like the oven to begin preheating. Press
OK to select.
The display reads AUTO START TEMP XXX. Use
the arrows to enter the desired preheat temperature.
Press OK to select.
Programming Oven Setup
These menus allow the manager to set up basic oven
functions
1. Use the arrows to highlight OVEN SETUP. Press
OK to select.
2. Use the arrows to highlight MANAGER PROGRAM.
Press OK to select.
3. Use the arrows to highlight the oven function you with
to change. Press OK to select. Choose from the fol-
lowing functions:
Recipe Password - Select YES or NO to enable
password protection on recipe programming. If YES
is selected the passcode 3124 must be entered to
change recipe programming.
Temp Unit - Select either degrees F or C.
Cool Down Temp - Select the set temperature for
the oven to achieve in Cool Down mode
Temp Disp Rate - Set the rate, in seconds, at which
the display switches between actual and setpoint
temperature
Input Rsp Time - Set the length of time allowed to
input each variable when programming recipes be-
fore control automatically exits out
Setback Time - When not used for a period of time,
the oven temperature will automatically reduce to
conserve energy. This variable sets the length of time
the oven remains at the idle temperature before be-
ing lowered.
Ready Beep - Select either ON or OFF. This is the au-
dible alarm that sounds when the oven has reached
the set temperature.
Cook Cool Fan - Select either YES or NO. This func-
tion allows the control to display OPEN OVEN DOOR
when you are attempting to lower the set temperature
of the oven.
Restore Manual - Select either YES or NO. This
variable enables the oven to remember the last set-
tings used for manual cooking.
4. After editing a function, press OK to save.
5. When all desired functions have been edited, use the
arrows to highlight EXIT. Press OK to exit the man-
ager programming mode.
To Next Page
Loading...
Need help?
General
