EasyManua.ls Logo

Blodgett HV-100EM - Supply Water and Plumbing

Blodgett HV-100EM
39 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
Installation
Supply Water and Plumbing
WATER CONNECTION
NOTE: Must use COLD WATER ONLY.
A shut off valve is to be provided adjacent to the oven.
WARNING!!
Operating the appliance without a water
regulator installed will invalidate your war-
ranty.
This product must be installed by a licensed Plumber or
Gas Fitter when installed within the Commonwealth of
Massachusetts.
DRAIN CONNECTION
The drain should be run to an open oor drain avoiding
exible hose that could sag and allow trapped water to
accumulate.
Specic water/drain connection for City of Los An-
geles
1. Each drain line from the appliance shall be routed
without dips or sags to terminate above the ood level
rim of an approved indirect waste receptor.
2. The appliance shall be installed in accordance with
the manufacturers printed instructions and the LAPC
and LAMC, 1999 editions.
3. A backow protection device may be required by lo-
cal codes. If so, install on the potable water system
directly ahead of the appliance. The backow protec-
tion device shall be any of the following: an approved
pressure type vacuum breaker installed at least 12”
above the highest point of use, a double check valve
backow preventer or a reduced pressure principal
backow preventer.

Other manuals for Blodgett HV-100EM

Related product manuals