ACM200 USER MANUAL
45contact support@blustream.co.uk / support@blustream.com.au
Transmitter (Input) Commands
COMMAND DESCRIPTION COMMAND RESPONSE
Set CEC INPUT:yyy ON or O INyyyCECON/OFF Set input xxx cec mode ON/OFF
Set TX Audio source to HDMI audio INyyyAUDORG Set Audio source:xxx to audio select
hdmi
Set TX Audio source to Analog INyyyAUDANA Set Audio source:xxx audio select
analog
Set TX Audio source to Auto INyyyAUDAUTO Set Audio source:xxx audio select
auto
Reboot Transmitter
INyyyRB
Set output xxx reboot and apply all
the new config
Copy EDID Input yyy from Output xxx EDIDyyyCPxxx Copy outputxxx edid to input yyy
Set Input: yyy EDID To EDID:zz
zz=00: HDMI 1080p@60Hz, Audio 2CH PCM
zz=01: HDMI 1080p@60Hz, Audio 5.1CH PCM/DTS/ DOLBY
zz=02: HDMI 1080p@60Hz, Audio 7.1CH PCM/DTS/DOLBY/HD
zz=03: HDMI 1080i@60Hz, Audio 2CH PCM
zz=04: HDMI 1080i@60Hz, Audio 5.1CH PCM/DTS/DOLBY
zz=05: HDMI 1080i@60Hz, Audio 7.1CH PCM/DTS/DOLBY/HD
zz=06: HDMI 1080p@60Hz/3D, Audio 2CH PCM
zz=07: HDMI 1080p@60Hz/3D, Audio 5.1CH PCM/DTS/DOLBY
zz=08: HDMI 1080p@60Hz/3D, Audio 7.1CH PCM/DTS/DOLBY/
HD
zz=09: HDMI 4K@30Hz 4:4:4, Audio 2CH PCM
zz=10: HDMI 4K@30Hz 4:4:4, Audio 5.1CH DTS/DOLBY
zz=11: HDMI 4K@30Hz 4:4:4, Audio 7.1CH DTS/DOLBY/HD
zz=12: DVI 1280x1024@60Hz, Audio None
zz=13: DVI 1920x1080@60Hz, Audio None
zz=14: DVI 1920x1200@60Hz, Audio None
zz=15: HDMI 4K@30Hz 4:4:4, Audio 7.1CH(Default)
zz=16: HDMI 4K@60Hz 4:2:0, Audio 2CH PCM
zz=17: HDMI 4K@60Hz 4:2:0, Audio 5.1CH DTS/DOLBY
zz=18: HDMI 4K@60Hz 4:2:0, Audio 7.1CH DTS/DOLBY/HD
EDIDyyyDFzz
Set input yyy edid with default edid
zz
Single Transmitter (input) status
INyyySTATUS
(See status example at end of docu-
ment)
To Next Page
Loading...
Need help?
General