Bosch Access Modular Controller 2 User Manual

Access Modular Controller 2 Introduction | en 13
Bosch Security Systems B.V.
Guide d'installation
2022-11 | V04 |
3.3 System overview
The controller can be connected to the host system through one of the following interfaces,
depending on the type of installation:
– Ethernet
– RS-485 multi-dropped, not supported by:
– BIS 4.9.1 and later
– AMS 4.0 and later.
The host interface is selected during installation.
The four reader interfaces are available on the device.
With RS485 operation, a maximum of eight access controllers can be connected to one party
line.
2
3
3
2
1
2 2
3
3
4 4
1 Host computer
2 Access Modular Controller
3 Card reader
4 Communication and power supply
In the communication chain of a system, the access controller is integrated between the host
system and the peripheral devices.
It is possible to connect a maximum of eight readers to the access modular controller.
The four reader interfaces are divided into two physical buses. Interface 1 and 2 are on one
bus, and interfaces 3 and 4 are on the other bus. This gives the advantage in cabling: longer
cable lengths can be used (1200m maximum per bus). Internally the buses are processed as
one interface. With this arrangement, you can connect all readers to one interface.

Bosch Access Modular Controller 2 Specifications

General

Brand	Bosch
Model	Access Modular Controller 2
Category	Controller
Language	English