Bosch Access Modular Controller 2 User Manual

Access Modular Controller 2 Installing | en 21
Bosch Security Systems B.V.
Guide d'installation
2022-11 | V04 |
4.8 Ethernet host interface
The controller offers a 10/100 Mbit/s Ethernet auto-sensing interface to connect to a local
area network or host computer.
i
Notice!
Use a CAT5 network cable or higher version to connect the controller with the network.
Figure4.9: Location of the Ethernet interface
i
Notice!
After connecting a new controller to a network using DHCP, it can take some time before the
new controller is recognized by the remote server.
You can accelerate this process by running the following command in a command console:
ipconfig /flushdns
This makes the controller immediately available by its name.
i
Notice!
When using an Ethernet connection, switches 1 and 5 of the DIP switch must be set to the
ON position (= factory setting) (see Figure 3.3, item 1 , page 10 ). This also ensures correct
communication with the Bosch Building Integration System (BIS) and the Bosch Access
Management System (AMS).
i
Notice!
When a controller is connected to a new switch, is powered up or detects a new network link
(after the reboot of the switch or the replacement of the cable, for example), the controller
broadcasts its presence over the network.

Bosch Access Modular Controller 2 Specifications

General

Brand	Bosch
Model	Access Modular Controller 2
Category	Controller
Language	English