Bosch Access Modular Controller 2 - Tamper Protection (4.14)

Access Modular Controller 2 Installing | en 33
Bosch Security Systems B.V.
Guide d'installation
2022-11 | V04 |
4.14 Tamper protection
To protect the AMC2 against unauthorized access and so prevent tampering with sensitive
data, the AMC2 provides an additional interface to connect external tamper contacts. This
interface is a potential-free 2-pin pluggable screw connector marked with T. When not in use
this tamper contact should be shorted.
Figure4.24: Location of the tamper protection contact