Bosch Access Modular Controller 2 User Manual

Access Modular Controller 2 Table of contents | en 3
Bosch Security Systems B.V.
Guide d'installation
2022-11 | V04 |
Table of contents
1
Safety 5
2
Short information 7
3
Introduction 8
3.1 Description 8
3.2 Product overview 10
3.2.1 Mainboard 10
3.2.2 Status display 12
3.3 System overview 13
4
Installing 14
4.1 Mounting the device on a mounting rail 14
4.2 Unmounting the device from a mounting rail 14
4.3 Opening the case 15
4.4 Closing the case 16
4.5 Cabling 17
4.5.1 Conductor data for powering the controller 17
4.6 Grounding and shielding 18
4.6.1 Grounding for host interface 18
4.6.2 Grounding for extension interface 19
4.6.3 Grounding for bus interfaces 19
4.7 Connecting the power supply to the controller 20
4.8 Ethernet host interface 21
4.9 RS-485 host interface 22
4.9.1 RS-485 Two Wire Connection 23
4.9.2 RS-485 Four Wire Connection 23
4.9.3 DIP switch selector 23
4.10 RS-485 for extension modules 26
4.11 RS-485 interface for card readers 27
4.11.1 RS-485 data bus system conditions 27
4.11.2 Power reader 28
4.12 Connecting relay outputs 29
4.13 Connecting analog input devices 31
4.14 Tamper protection 33
5
Operating 34
5.1 Configuring Ethernet interface 34
6
UL requirements 35
6.1 System requirements 35
6.1.1 Computer 35
6.2 UL 294 level descriptions 35
6.3 Installation instructions 36
6.4 Extended technical specification 38
6.4.1 RS-485 extension 38
6.4.2 Power consumption 38
7
Troubleshooting 39
7.1 Resetting the software 40
7.2 Resetting the device to factory default 41
8
Service and repair 42
9
Disposal 43
10
Technical specifications 44

Bosch Access Modular Controller 2 Specifications

General

Brand	Bosch
Model	Access Modular Controller 2
Category	Controller
Language	English