To Next PageTo Next PageTo Previous PageTo Previous Page
What to do if my Bosch Controller is not online?
If your Bosch Controller is not online, first, plug the Ethernet cable into the controller to establish a network connection. Second, check the DIP switch 5 setting. If it's set to OFF (BPA protocol), set it to ON (SDEB protocol).
Why doesn't my Bosch Controller work as expected?
If the Bosch Controller does not work as expected, try these steps: 1. Switch the power of the controller off and on again. 2. Check the configuration of the controller. If necessary, delete all configuration data by Resetting the Device to Factory Default. 3. Reset the controller as described in Resetting the software.
What to do if there is no connection to BIS and AMS after a factory reset on a Bosch Access Modular 2 Controller?
If you're experiencing no connection to BIS and AMS after a factory reset on your Bosch Controller, it might be due to the following reasons: There is no connection to access system, so check the configuration settings within the AMS or ACE system. Also, verify that the controller is activated in the configuration settings.
How to fix a Bosch Access Modular 2 when the display is not working?
General| Brand | Bosch |
|---|---|
| Model | Access Modular Controller 2 |
| Category | Controller |
| Language | English |
