Cross zone/unverified alarm 1023 0
VDS-A EN=0
Domestic no. 1024 0
Zone reaction time 1025 – 1028 0003
*For an explanation of the zone types, refer to Add / Delete Zone, page 53.
For the zone functions 02 to 15 the same options as for zone functions 01 can be programmed
with the same number of addresses for each option:
– Selection of a zone type: 2 addresses each
– Allow bypass/force arm: 1 address each
– Silent alarm/chime mode: 1 address each
– Pulse count: 1 address each
– Zone lockout: 1 address each
– Zone DEOL: 1 address each
– Report: 1 address each
– Cross zone/unverified alarm: 1 address each
– Domestic no.: 1 address each
– Zone reaction time: 4 addresses each
The default values for zone functions 02 to 15 are the same as the default values of zone
functions 01, except for the option “Selection of a zone type”.
The following addresses are used for programming the zone functions 02 to 15:
Zone function
Option Address Default
02 Selection of a zone type* 1030 – 1031 02
Remaining options as shown above 1031 – 1043 3003160
00003
03 Selection of a zone type* 1045 – 1046 03
Remaining options as shown above 1047 – 1058 3003160
00003
04 Selection of a zone type* 1060 – 1061 04
Remaining options as shown above 1062 – 1073 3003160
00003
05 Selection of a zone type* 1075 – 1076 05
Remaining options as shown above 1077 – 1088 3003160
00003
06 Selection of a zone type* 1090 – 1091 06
Remaining options as shown above 1092 – 1103 3003160
00003
07 Selection of a zone type* 1105 – 1106 07
Remaining options as shown above 1107 – 1118 3003160
00003
08 Selection of a zone type* 1120 – 1121 08
130 en | Address Programming AMAX panel
2015.05 | 06 | F.01U.309.277 Installation Manual Bosch Sicherheitssysteme GmbH
To Next Page
Loading...
