Bosch AMAX 2100 - Address Setting; Wiring; Status Indicator

Installation
1. Disconnect all power supplies of the AMAX panel before installing ITS-DX4020-G.
2. Insert SIM card.
3. Use the standard three-hole installation mode to install the ITS-DX4020-G in the
enclosure of the AMAX panel or another enclosure.
4. Connect the magnetic antenna to ITS-DX4020-G.
For information on the installation, refer to Module Installation, page 26.
Address Setting
Set bus address to 134.
Wiring
The following graphics show how to wire ITS-DX4020-G to the option bus of the AMAX panel.
Two modes are possible: GPRS and GSM
AMAX 3000 BE / 4000
Y
R
Y
G
B
AMAX 2100 / 3000
R
B
G
DX4020G
R
B
G
Y
Figure 4.11: GPRS mode in support of IP
DX4020G
BUS
AMAX 3000 BE / 4000
R
Y
G
B
RING
TIP
RH
TH
R
B
G
Y
PNL
PSTN
TIP
TIP
1RING
1RING
R
Y
G
B
AMAX 2100 / 3000
Figure 4.12: GSM mode in support of PSTN (Contact ID)
Status Indicator
Normally, the AMAX panel tests the communication with the module. In case of a
communication failure, a fault report including the module address is sent.
The following table describes the status LED indicator of DX4020-G.
4.8.2
4.8.3
4.8.4
AMAX panel Optional Modules and Peripheral Devices | en 23
Bosch Sicherheitssysteme GmbH Installation Manual 2015.05 | 06 | F.01U.309.277