Bosch AMAX 2100 - Page 88

0-disable 1-enable
DUAL IP
REM. ACCESS ARMED
REMOTE ACCESS
1
0-1 ip module
0
RPC IP/ PORT/ POLL
RPC ACCESS CODE
1
0 = Panel does not answer
1 - 13 = Number of rings until the control panel responds
14 = Call the control panel and allow the phone to ring no
more than twice and hang up. Wait a minimum of 8 sec and
call the control panel again. The control panel answers on
the first ring.
15 = Call the control panel and allow the phone to ring no
more than four times and then hang up. If you call again
within 45 sec, the control panel answers the call on the first
ring.
CALLBACK/DOMEST No
DOMESTIC No (1-4)
CHANGE DOM PHO. No
15
Default
EN=1-24
24
TEST RPT INTERV: h
0-disable 1-enable
99
1
REMOTE PSTN ACCESS
Certification
Parameters / Description
RPC PORT 5 DIGIT!
00 = Do not use timing report 01 - 99 = 1 - 99 hours
TEST REPORT DURAT.
TEST REPORT: hour
TEST REPORT: min
1
RPC IP ADDRESS
REMOTE IP ACCESS
Menu Items
1-2 ip modules
00 - 59 minutes Others = Do not use real-time report
00 - 23 hours Others = Do not use real-time report
CALLBACK SETTING
0-disable 1-enable
CALLBACK/ DOMESTIC
DOMESTIC CALL
99
CALLBACK PHONE No
RPC POLL: 1-15h
14
0-disable 1-enable
RING TIMES
Figure 7.2: Communications and Reporting Manager (continued)
88
en | Configuration AMAX panel
2015.05 | 06 | F.01U.309.277 Installation Manual Bosch Sicherheitssysteme GmbH