Safety Instructions
1--6
1070 072 196-101 (00.06) GB
CAUTION
Danger to the module!
All ESD protection measures must be observed when using themod-
ule! Prevent electrostatic discharges!
Observe the following protective measures for electrostatically endangered
modules (EEM)!
D The Employees responsible for storage, transport and handling must be
trained in ESD protection.
D EEMs must be stored and transported in the protective packaging speci-
fied.
D Out of principle, EEMs may be handled only at special ESD work stations
equipped for this particular purpose.
D Employees, work surfaces and all devices and tools that could come into
contact with EEMs must be on the same potential (e.g. earthed).
D An approved earthing wrist strap must be worn. It must be connected to
the work surface via a cable with integrated 1 MΩ resistor.
D EEMs may under no circumstances come into contact with objects sus-
ceptible to accumulating an electrostatic charge. Most items made of
plastic belong to this category.
D When installing EEMs in or removing them from an electronic device, the
power supply of the device must be switched OFF.
To Next Page
Loading...
