EasyManua.ls Logo

Bosch CL500 - Special Commands

Bosch CL500
96 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
General Information Regarding BUEP-E and BUEP19E
7--11
1070 072 196-101 (00.06) GB
7.2.2 Special Commands
Identification Command 76
H
Command Identification Command
Command code 76
H
Command attribute Control code
Address high part Block address
Address low part 0
Type of operand 0
Description of the control codes:
High Byte Low Byte
7 6 5 4 3 2 1 0 Identification number
Identification number other than FF
H
Bit 0 0
1
Without identification code
With identification code
Bit 3 0
1
Without protocol priority
With protocol priority
Bit 4 0
1
Take over identification number
Do not take over identification number
Bit 5 to 7 0 Reserved
Description of the identification codes:
Device identification Word CL500 16#0000
Type identification Word COM-E 16#3084
SW version Byte Binary code
HW version Byte Binary code
Module block address Word

Related product manuals