R5REQ
5--5
1070 072 196-101 (00.06) GB
5.3 Meaning of the Parameters in the Data Storage Area
For each job, a parameter field of 16 words must be reserved in the data field
(DF), the data buffer (DB), or the data module (DM).
The address and the offset of this data storage area is determined with the
parameters P0 to P2 of the R5REQ.
Each parameter field will be assigned a bit in the ABL job bit bar and a bit in
the EBL result bit bar, starting at bit 0.
Below, you find an example of the corresponding data storage area if the pa-
rameter P2 (offset) has the value 0:
Job Bit of the ABL Corresponding Data
Storage Area
Byte Addresses
0 DW0toDW15 0to31
1 DW16 to DW31 32 to 63
2 DW32 to DW47 64 to 95
3 DW48 to DW63 96 to 127
4 DW64 to DW79 128to159
5 DW80 to DW95 160to191
6 DW96 to DW111 192to223
7 DW112 to DW127 224to255
8 DW128 to DW143 256to287
9 DW144 to DW159 288to319
10 DW160 to DW175 320to351
11 DW176 to DW191 352to383
12 DW192 to DW207 384to415
13 DW208 to DW223 416to447
14 DW224 to DW239 448to479
15 DW240 to DW255 480to511
The maximally 16 job parameters are distinguished in two groups:
D Protocol-independent parameters
Their contents are always the same, no matter which protocol or which
service is addressed with the subsequent parameters.
D Protocol-dependent parameters
These parameters are different in all protocols or services.
To Next Page
Loading...
