R5CON
6--1
1070 072 196-101 (00.06) GB
6R5CON
6.1 Characteristics
Characteristics R5CON
Module name R5CON
Number of parameters 5
Reserved markers M230 to M254
Processing time 0.5 ms with ZS500
The function module R5CON controls centralized jobs. It is its task to send
information back to the user during processing as well as after the finished
job. To do so, it takes the status and the error word from the job table and
outputs this information to the address that the user has indicated as the pa-
rameter.
With R5CON only one job per call or all error-free and one faulty job can be
acknowledged. The R5CON forwards the status and the error word from the
job table to the PLC program. If all error-free jobs are acknowledged, the sta-
tus and the error word only contain the information about the one applicable
faulty job.
The R5CON must acknowledge all jobs that have been allocated by the
R5REQ and the results of the single jobs are read out. For unconfirmed ser-
vices, a local acknowledgement is generated.
Only after the acknowledgement is read out, a new job can be started with
this job number.
6.2 Parameters
The function module R5CON is provided with two input and three output
parameters.
P0
P2
R5CON P3
P1
P4
To Next Page
Loading...
