Hardware
2--3
1070 072 196-101 (00.06) GB
Reset Button
Pressing the reset button starts reinitialization of COM-E’s operating soft-
ware.
D All active jobs are aborted undefined.
D All jobs are deleted from the job queue.
D STOP and CLAB requests of the module are deleted.
Link-LED
This LED indicates that the link integrity signals can be exchanged between
COM-E and the coupled partner device. This way it is possible to enable a
communication between both stations.
Receive/Transmit-LED
These LEDs indicate the data traffic. They are lit when messages are going
out or coming in.
Identification of Version
This label identifies the revision level of the module. Changes are marked by
a black point.
Labeling Field
The labeling field is for you, the user, to identify the module according to your
plant’s identification system. This e.g. might be the module’s block address
or the IP address.
To Next Page
Loading...
