Hardware
2--17
1070 072 196-101 (00.06) GB
Ethernet-Overwrite
Default: 0 ; no overwrite
The Ethernet overwrite function causes the acceptance of the IP table’s
Ethernet address in the module if the IP address given in the system table is
identical with the address in the table.
Example:
D In the system table, the COM-E is listed with the IP address
142.2.40.123.
D Ethernet overwrite is set to 1.
D IP table:
IP Address Module
Name
Ethernet Address
[hex]
Comment
....
142.2.40.123 John 11-22-33-44-55-66 ;to be accepted
....
After loading the configuration file, the Ethernet address 11-22-33-44-55-66
will be taken over by the module.
Example for an entry in the configuration file:
Ethernet-Overwrite: 1 ; 0 = No overwrite (default)
; 1 = Overwrite
. The originally impressed Ethernet address is not overwritten. After de-
leting the configuration file, it will become visible again.
Subnet-Mask
Default: 255.255.0.0
This mask is only effective in combination with the default gateway address.
If a message is sent to another subnetwork, it is sent via the defined default
gateway.
Example for an entry in the configuration file:
Subnet-Mask: 255.255.255.0
Default-Gateway
Default: no default address
Gateway address to a subnetwork.
Example for an entry in the configuration file:
Default-Gateway: 142.2.1.100
To Next Page
Loading...
