R5REQ
5--3
1070 072 196-101 (00.06) GB
P3
Parameter Attribute Description
P3 W Job bit bar ABL
Each of the 16 bits of this parameter represents a reference to a block of job
parameters located in the data storage area determined by P0 to P2. Bit 0 of
P3 thus refers to the 0. job parameter block, and bit 15 refers to the 15. job
parameter block in the determined data storage area.
Setting a bit in P3 initiates the start of the job which is described in the corre-
sponding job parameter block. If several bits are set contemporarily, the cor-
responding jobs are passed to the COM-E in the same cycle.
One single execution of the R5REQ with set job bits already starts all those
selected jobs. The job bits must then be reset using the application program.
To Next Page
Loading...
