R5CON
6--4
1070 072 196-101 (00.06) GB
P4
Parameter Attribute Description
P4 W Error message
In case of an error, i.e. high byte of P3 = 03
H
, the detailed error code is lo-
cated in P4. In general, the evaluation of this code is only required during
commissioning or in case of service.
The error message is available for one PLC cycle only.
Detailed error descriptions are available:
D for BUEP03E and BUEP64 in the R500 manual, order no. 1070 072 131
D for BUEP-E and BUEP19E in chapter 7.3.3
To Next Page
Loading...
