DCN-IDESK Interpreter Desks
When you start the central control unit, the interpreter desk starts. The display on the desk
shows the hardware and software versions. For example:
The operational mode starts automatically if the desk has the correct configuration. The
operational mode is the default mode for the interpreter desk. If the desk is not configured,
the display shows the screen:
Notice!
You cannot put a desk that is not configured in the operational mode.
Normal interpretation
In the usual procedure for interpreters, the interpreter knows the source floor language. The
interpreter makes an interpretation of the source language in the target language. The
language distribution channels transmit the target language to the delegate units.
Figure 8.3: Normal interpretation from floor
Auto-relay interpretation
Where the interpreter does not know the source floor language, the system has an automatic
relay function.
One interpreter makes an interpretation from the source language (floor signal) in a language
that the other interpreters know. This language is the auto-relay interpretation. The auto-relay
interpretation automatically replaces the floor signal on all interpreter desks. All interpreters
use the auto-relay interpretation to make interpretations.
The example in the figure shows that the floor signal is Chinese. The auto-relay is enabled at
the Chinese interpreter desk. The Chinese-to-English interpreter selects output B and sends
an English auto-relay interpretation to all other interpreter desks. The LED adjacent to the
Floor/Auto-relay button shows on all other interpreter desks that the interpreter desk receive
an auto-relay interpretation.
8.16
252 en | Operation Conference System
2013.11 | V2.0 | DCN-NG_OM_V4.x Operation Manual Bosch Security Systems B.V.
To Next Page
Loading...
