System settings (Service menu – Settings)
Logamatic EMS – 6 720 801 387 (2011/05)
42
6
Should the LED of the single
charge key be activated?
Yes, No Yes The single loading function
remains, but it is not displayed
via LED.
5)
Start delay in case of preheated
DHW (e.g. solar)
Off,
1 second to 50
seconds
OFF This function depends on the
boiler used.
1) Not possible or available on boilers with UBA1.x, UBA-H3 or DBA.
2) Not possible or not available with boilers with UBA1.x or DBA.
3) With boilers with UBA-H3 depending on the existence of a PZ output (e.g. on module LM10)
4) Subject to the boiler in use, the temperature is permanently fixed an cannot be modified.
5) Not possible or not available with boilers with UBA1.x.
Menu item Input range
Standard
setting Other information
Table 16 Navigator for service menu SETTINGS\DHW
To Next Page
Loading...
